Seven Bass Extasy Glue

Working temperature:
18 ° C to 30 ° C
The adhesive and the materials to be bonded must not be used at a temperature below + 18 ° C. An
adhesive exposed to low temperatures must be well mixed and tempered at a temperature of 18 - 30 ° C
minimum 72 hours before use.

Surfaces to be bonded must be clean, dry, free of dust and any grease.

Gluing:
Apply a thin film of fine and regular glue on the two materials to be assembled. After the aeration time
of 2 to 5 minutes display both materials. The open time as well as the aeration time is a function of the
ambient temperature, the thickness of the layer applied and the absorbency of the supports. As soon as
the solvents are evaporated, the glue film becomes dull and the two supports can then be reactivated
at a temperature of approximately + 70 ° C and displayed direct ly by exerting a good contact pressure.
In some cases, it is possible to accelerate the drying by a heating tunnel which allows to reactivate in stride.

Storage:
Do not store more than 6 months at room temperature in the original unopened packaging at a temperature of 15 ° C to 25 ° C. Always tightly close the packaging during use to avoid thickening of the college linked to evaporation of solvents.

Security:
Avoid direct contact with the product and work in well-ventilated rooms or better, provide suction at the work station. Wearing gloves, a mask and protection is advised. Please observe the directives on the use of dangerous substances and the measures applicable in the event of an accident.
For further information, please read carefully the Safety Data Sheet which we hold at your disposal on simple written request.

Composition:
Polyurethane resin, toluene, acetone, MEK, ethyl acetate